湖南除尘设备有限公司|湖南除尘设备厂家|麦迪环保设备厂

PPC(FGM)-MD系列气箱脉冲袋收尘器
PPC(FGM) –MD Series Plenum Pulse Bag Filter
【概述Introduction】
PPC（FGM）系列袋收尘器主要适用于非爆炸性粉尘，可广泛应用于建材、冶金、电力等行业的破碎机、球磨机，立式磨、烘干机、O-Sepa 选粉机、立式冷却机、包装机等系统的收尘。
PPC(FGM) series bag filters are mainly applied to non-explosive dust. They are widely used to collect dust in crusher, ball mill, vertical mill, dryer, O-Sepa separator, grate cooler, packer, etc, in industries as building material, metrgy, electrical power, etc.

【特点简介Characteristics】
	能一次性处理含尘浓度高达1000g/Nm³烟尘
	*预收收尘设备，工艺流程简单
	袋室内*喷吹管，拆换袋方便
	嵌入式弹性袋口，密封性能好
	脉冲阀数量少，清灰强度大，动作迅速
	整机采用微机自动控制，各控制参数易于调节，投入自动是，可实现无岗位工操作。
	Able to treat smoke with dust concentration 1000g/Nm³ at one time
	No equipment for pre-collecting dust is necessary，which brings out a simple process flow
	without jet pipe in bag chamber，it is convenient to replace bags
	The embedded elastic bag mouth helps in good sealing
	Number of pulse values is small; operation of removing dust is highly efficient
	The whole equipment is automatically controlled by computer. under automation mode，no person is needed for operation.

【技术指标Technical Indexes】
	当收尘器入口浓度≤1000g/Nm³时，出口排放≤30mg/Nm³
	壳体耐压9000Pa
	滤袋使用寿命二年以上
	收尘器相对主机运转率**
	When concentration at inlet is ≤1000g/Nm³, emission concentration at outlet is ≤30mg/Nm³.
	at outlet is 30 mg/Nm³.
	Pressure the shell can bear reaches 9000Pa.
	Service life of filter bags is longer than 2 years.
	The operation rate of dust collect to main equipment is **.
LMCD(CDMC)系列长袋脉冲布袋式除尘器
LMCD (CDMC) Series Long-Bag Pulse Bag Pulse Filter

【特点简介Characteristics】
	设计新颖，采用下进气结构，较粗的高温颗粒直接落入灰斗，有效的保护了滤袋
	采用长滤袋，在同等处理能力时设备占地面积少，更便于老厂改造
	采用分室离线清灰，效率高，粉尘的二次吸附少，同时有效的降低了设备能耗，滤袋与脉冲阀的疲劳程度也相应降低，成倍地提高了滤袋和阀片的寿命，大量减少了设备运行维护的费用
	检修换袋可在不停系统风机、系统正常运行的条件下分室进行
	滤袋袋口采用弹簧涨紧结构，拆装方便，具有良好的密封性
	箱体经过气密性设计，并以煤油捡漏，较大程度减少漏风
	整台设备由PLC机控制，实现自动清灰、卸灰、自动温度控制及**温报警
	Hopper directly to effectively protect filter bags.
	With long bags, equipment takes less area compared with others in the same capacity. It is especially favorable for upgrading of existing plants.
	Off-line dust removal in separate chambers featured as follows: high efficiency: less secondary dust re-adhering: lower power consumption; extended service life of bags and valve plate due to less fatigue. in this way, expense for equipment maintenance could be greatly reduced.
	Maintenance and replacement of bag can be separately conducted in each chamber without interrupting the whole operation system and fans.
	Apply spring take-up at bag mouth for easy maintenance and replacement and favorable air tightness.
	The design of shell takes air tightness into consideration and use kerosene for inspection, so as to reduce air leakage to the largest extent.
	Equipment is controlled through PLC to realize automatic dust removal, dust discharge, temperature control and over-temperature alarming.